![]() ![]() Reboot the RPi (yep its stupid but weâve found a reboot to be needed even after removing and re-inserting the SD card), sudo startx, run gparted, select the USB drive and check the ext4 partition is locked again (mounted) and has its boot string back. ![]() Right click the main âext4â partition and select âcheckâ (weâve found this to be necessary to ensure the new partition size is correctly updated in the file system even though it should be done as part of the resize â kept us chasing constantly failed resizes for hours before we discovered this).įinally click the green arrow button to carry out the changes. Right click the main âext4â partition and select âresizeâ then enter the new size you want it to be. Right click the main âext4â partition and select âcheckâ, then click the green tick and let it check the partition for you (this isnât essential but its a good idea as if there are issues it will likely cause the resize to fail). Right click somewhere on the graphic and select âunmountâ first as operations canât be carried out on a mounted partition. If I had a monitor connected, I'm imagining I would see a transition. 1) From command line, if I execute startx, X11 will launch followed by LXDE. Then from the start menu select run and enter âgpartedâ Resizing Your Main Partitionįrom the top bar devices drop down select âdev/sdaâ (or whatever your external USB adaptor has been called). I have a Raspberry Pi with Debian Wheezy (Raspbian) and so far I've managed to learn quite a lot about Linux just playing around, but I have a few questions for all you seasoned Linux pros out there. To run it use âsudo startxâ to load the GUI as gparted needs root user privileges <<youâd rather use a windows tool weâve found that gparted just works whereas all of the windows based partition managers we tried donât, so better to just get over the hassle factor and use the RPi to do this if you donât have a separate Linux system. You can now use the raspberry pi using terminal commands or boot the Pi into its GUI Desktop by typing startx. To do this youâll need to put the SD card you want to work on in a USB to SD card adaptor and boot your RPi from a separate SD card. It can also be used to check and repair a SD card disk. ![]() âgpartedâ is the graphical version of âpartedâ and is the tool to use to resize the main partition used for raspbian (or you could use use parted if you prefer the command line of course!). ![]()
0 Comments
Leave a Reply. |